LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Torque Converter Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Turbine Shaft O-Ring Seal On Turbine Shaft
    GM13054Courtesy of GENERAL MOTORS CORP.
  1. Apply J 36850  or equivalent to a new turbine shaft O-ring seal (520).
  2. Apply J 36850  or equivalent to the turbine shaft (518) splines.
  3. Install the turbine shaft O-ring seal (520) onto the turbine shaft (518).
    4. Fig 2: View Of Torque Converter Assembly
    GM47958Courtesy of GENERAL MOTORS CORP.
    CAUTION: The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly.
  4. Install the torque converter assembly (1).
scientia non olet · About LEMON Manuals