LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Thermo Element Adjustment >> Adjustment Procedure

Adjustment Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Thermo Element
    GM13015Courtesy of GENERAL MOTORS CORP.
  1. Remove the thermo element plate pins (120).
  2. Remove the thermo element (121) and the thermo element plate (122).
    3. Fig 2: Using J 34094-A To Set The Height Of The Thermo Element Plate Center Pin
    GM13016Courtesy of GENERAL MOTORS CORP.
  3. Use J 34094-A  in order to set the height of the thermo element plate center pin (123). See Special Tools .
  4. Install the thermo element plate (122).
  5. Use J 34094-A  in order to set the height of the thermo element plate pin (120) that is farthest from the accumulators. See Special Tools .
  6. Use J 34094-A  in order to set the height of the second thermo element plate pin (120). See Special Tools .
    7. Fig 3: Removing Thermo Element
    GM13015Courtesy of GENERAL MOTORS CORP.
  7. Carefully install the thermo element (121) between the two thermo element plate pins (120).
  8. The V in the thermo element (121) must contact the thermo element plate (123).
scientia non olet · About LEMON Manuals