LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Second Clutch Disassemble >> Disassembly Procedure

Disassembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Second Clutch Plate Assembly
    GM48711Courtesy of GENERAL MOTORS CORP.
  1. Use a flat blade screwdriver in order to remove the retaining ring (627) from the second clutch housing.
  2. Remove the second clutch backing plate (626). Remove the alternating second clutch fiber plates (624). Remove the second clutch steel plates (625).
  3. Remove the second clutch apply plate (716). Remove the second clutch waved plate (623).
    4. Fig 2: Using J 23327 & J 38734 To Compress The Second Clutch Piston Spring
    GM840855Courtesy of GENERAL MOTORS CORP.
  4. Use J 23327  (1) and J 38734  (2) in order to compress the second clutch piston spring (621).
  5. Remove the retaining ring (622).
  6. Remove J 23327  and J 38734  from the second clutch housing (617).
    7. Fig 3: Identifying Second Clutch Spring Assembly
    GM49039Courtesy of GENERAL MOTORS CORP.
  7. Remove the second clutch spring assembly (621).
  8. Remove the second clutch piston assembly (620).
scientia non olet · About LEMON Manuals