LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Reverse Servo Removal >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Reverse Servo Cover Snap Ring
    GM48166Courtesy of GENERAL MOTORS CORP.
  1. Use a long screwdriver in order to depress the reverse band servo cover (40) by prying against the transmission holding fixture.
  2. Use a small screwdriver in order to pry out the retaining ring (39) from the reverse band servo cover.
    3. Fig 2: Identifying Reverse Servo Assembly Components
    GM48173Courtesy of GENERAL MOTORS CORP.
  3. Remove the long screwdriver. The servo assembly will push the servo cover (40) up.
  4. Remove the servo cover (40) and the servo cover O-ring seal (41).
  5. Remove the reverse band servo assembly (42-48).
  6. Remove the reverse band servo piston spring (49).
scientia non olet · About LEMON Manuals