LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Manual Valve Link and Oil Dam Removal >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Manual Shift Detent Assembly
    GM870968Courtesy of GENERAL MOTORS CORP.
  1. Remove the manual shift detent bolt (805).
  2. Remove the manual shift detent assembly (804).
    3. Fig 2: View Of Oil Dam
    GM870971Courtesy of GENERAL MOTORS CORP.
  3. Compress the manual valve link spring (403) from the manual valve (404).
  4. Lift the manual valve link (402) off of the manual valve (404).
  5. Position the manual valve link (402) so that the valve will not interfere with the case cover removal.
  6. Remove the oil dam (27) from the case.
    7. Fig 3: View Of Input Speed Sensor
    GM48196Courtesy of GENERAL MOTORS CORP.
  7. Using a small screwdriver, pry the input speed sensor clip (441) out of the case cover (400).
    8. IMPORTANT: Handle the speed sensor carefully.
  8. Carefully pull the input speed sensor (440) out of the case cover (400).
scientia non olet · About LEMON Manuals