LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Manual Valve Link and Oil Dam Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Dam
    GM870971Courtesy of GENERAL MOTORS CORP.
  1. Install the oil dam (27) into the case.
  2. Assemble the manual valve link onto the manual shift detent lever/IMS detent lever.
    3. Fig 2: Connecting Manual Valve Link To Manual Valve
    GM48183Courtesy of GENERAL MOTORS CORP.
  3. Connect the manual valve link (402) to the manual valve (404).
  4. Install the manual valve link spring (403).
    5. Fig 3: Locating Manual Shift Detent Assembly
    GM870968Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the manual shift detent assembly (804) and the manual shift detent bolt (805).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

    6. Fig 4: View Of Input Speed Sensor
    GM48196Courtesy of GENERAL MOTORS CORP.
  6. Carefully install the input speed sensor (440) into the case cover (400).
  7. Install the input speed sensor clip (441) into the case cover (400).
scientia non olet · About LEMON Manuals