LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Input Clutch Housing, Input Clutch Pawl and Third Clutch Pawl Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sprag Clutch Assembly
    GM897578Courtesy of GENERAL MOTORS CORP.
  1. Use a small screwdriver in order to align the teeth of the input clutch plate assembly and the third clutch plate assembly. This will ease installation of the clutch pawl assembly.
    2. IMPORTANT: Make sure that the clutch pawl assembly is fully seated into the housing.
  2. Insert the combined input clutch pawl (728), third clutch pawl (727) and input sun gear (668) assembly into the input clutch housing assembly (632).
scientia non olet · About LEMON Manuals