LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Input Clutch Housing Oil Seal Rings Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing J 34741-1 Into The Input Clutch Housing
    GM10655Courtesy of GENERAL MOTORS CORP.
  1. Install J 34741-1  into the input clutch housing (632). See Special Tools . Adjust J 34741-1  so that the bottom of the seal installer aligns with the lowest seal ring groove. See Special Tools .
  2. Use transmission fluid in order to lubricate the oil seal ring for the input clutch housing. Position the ring on the J 34741-1  . See Special Tools .
    3. Fig 2: Using J 34741-2 & J 34741-1 To Install Seal Rings
    GM10657Courtesy of GENERAL MOTORS CORP.
  3. Position J 34741-2  onto the J 34741-1  . See Special Tools . Push the seal (628) into the seal ring groove.
    4. Fig 3: Locating Second & Third Seal Rings
    GM10656Courtesy of GENERAL MOTORS CORP.
  4. Repeat this procedure for the second and the third seal rings (628).
    5. Fig 4: Installing J 34741-3 Over The Seals
    GM10658Courtesy of GENERAL MOTORS CORP.
  5. Remove the input seal installer.
  6. Use a twisting motion in order to assemble J 34741-3  over the seals. See Special Tools .
  7. Leave J 34741-3  in place until the input clutch housing assembly (632) is assembled into the transmission. See Special Tools .
scientia non olet · About LEMON Manuals