Assembly Procedure
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the forward band servo components for the following conditions:
- Damaged, worn or porous servo piston (16)
- Damaged servo piston oil seal ring (18)
- Damaged, worn or porous servo cover (13)
- Damaged servo cover seal (14)
- Broken or collapsed servo piston return spring (22)
- Broken or collapsed servo piston cushion inner spring (65)
- Broken or collapsed servo piston cushion outer spring (19)
- Damaged or worn servo piston apply pin (21)
- Assemble the servo piston (16), the servo piston cushion outer spring (19), the servo piston cushion inner spring (65), the servo cushion spring retainer (20) and the servo piston apply pin (21).
- Install the servo pin retaining ring (15) onto the servo piston apply pin (21).
- Install the servo piston oil seal ring (18) onto the servo piston (16).
- Assemble the servo piston return spring (22) onto the servo assembly.
- Position the transmission so that the oil pan is facing up.
- Install the servo cover seal (14) onto the servo cover (13).
- Assemble the servo assembly (15-22) into the servo cover (13). Pivot the servo assembly (15-22) into the servo cover (13) in order to prevent the piston oil seal ring from being damaged.
- Install the servo and cover assembly (13-22) into the case.
- Using a long screwdriver, pry against the work bench in order to compress the forward band servo assembly (13).
- Hold the servo assembly compressed.
- Install the 3 forward band servo cover bolts (12).
Tighten: Tighten the bolts to 12 N.m (106 lb in).
- Remove the long screwdriver.
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.