Inspection Procedure
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the driven sprocket support assembly (609) for the following:
- Worn or cut oil seal rings (612)
- Rolled or cut second clutch housing oil seal ring seals (613)
- Damage to the piston seal surface in the driven sprocket support assembly
- Blocked or porous oil passages in the driven sprocket support assembly
- A leaking or missing cup plug
- Inspect the fourth clutch piston (603) for damage.
- Inspect the thrust washer (611) from the second clutch housing for cracks or distortion.
- Inspect the fourth clutch spring assembly (602) for distorted or missing springs.
- Inspect the driven sprocket bearing assembly for foreign material and missing, flat or damaged rollers.
- Replace the Teflon® seal rings (613) under the following conditions:
- The rings are cut or damaged
- You are performing a complete overhaul
- Inspect all seal ring grooves for debris, burrs or damage.