LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Driven Sprocket Support Components Disassemble >> Disassembly Procedure

Disassembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Using J 4670-01 To Compress The Fourth Clutch Spring Assembly
    GM10670Courtesy of GENERAL MOTORS CORP.
  1. Use J 4670-01  clutch spring compressor in order to compress the fourth clutch spring assembly (602). See Special Tools . Remove the snap ring (601) from the driven sprocket support assembly.
    2. Fig 2: Removing Spring Assembly & Fourth Clutch Piston Assembly
    GM10671Courtesy of GENERAL MOTORS CORP.
  2. Remove the spring assembly (602) and remove the fourth clutch piston assembly (603) from the driven sprocket support assembly (609).
    3. Fig 3: Locating Fourth Clutch Piston Outer Seal
    GM10672Courtesy of GENERAL MOTORS CORP.
  3. Remove the outer seal (604) from the fourth clutch piston (603).
    4. Fig 4: Removing Inner Seal & Oil Seal Rings From Driven Sprocket Support
    GM788713Courtesy of GENERAL MOTORS CORP.
  4. Remove the inner seal (605) for the fourth clutch piston from the driven sprocket support assembly hub.
  5. Remove the oil seal rings (613) from the driven sprocket support.
scientia non olet · About LEMON Manuals