Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Fourth Clutch Piston Outer Seal

Courtesy of GENERAL MOTORS CORP.

Use transmission fluid in order to lubricate a new fourth clutch piston outer seal (604). Install the seal onto the fourth clutch piston assembly (603).

Fig 2: Identifying Fourth Clutch Piston Inner Seal

Courtesy of GENERAL MOTORS CORP.

Use transmission fluid in order to lubricate a new fourth clutch piston inner seal (605). Install the seal into the driven sprocket support hub.

Fig 3: Assembling Fourth Clutch Piston Assembly Into Driven Sprocket Support

Courtesy of GENERAL MOTORS CORP.

Insert the fourth clutch piston assembly (603) into the driven sprocket support (609) and align as shown.
Insert the fourth clutch return spring assembly (602) into the piston.

Fig 4: Using J 4670-01 To Compress The Fourth Clutch Spring Assembly

Courtesy of GENERAL MOTORS CORP.

Use J 4670-01 in order to install the fourth clutch spring retaining ring (601). See Special Tools .

Fig 5: Installing Second Clutch Housing Oil Seal Rings

Courtesy of GENERAL MOTORS CORP.

If you are installing new second clutch housing oil seal rings (613), lubricate the rings. Install the oil seal rings (613) onto the driven sprocket support hub (609).