LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Driven Sprocket Support Bearing Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Using J 34126 & J 8092 To Install Driven Sprocket Support Bearing Assembly
GM10677Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Position the driven sprocket support bearing assembly so that markings on the edge are facing up.

Use J 34126  , J 8092  and a hammer in order to seat the driven sprocket support bearing assembly flush with or below the driven sprocket support assembly (609) hub.

scientia non olet · About LEMON Manuals