LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Driven Sprocket Support Assembly Removal >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Driven Sprocket Support Assembly
    GM870974Courtesy of GENERAL MOTORS CORP.
  1. With your fingers, insert two 13 mm channel plate bolts (434) into the driven sprocket support assembly (609).
  2. Grasp the bolts and lift the support assembly from the case.
  3. Remove the thrust washer (611) from the second clutch housing. The washer may be stuck to the support assembly.
scientia non olet · About LEMON Manuals