LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Driven Sprocket Support Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Second Clutch Housing Thrust Washer
    GM10685Courtesy of GENERAL MOTORS CORP.
  1. Use J 36850  or equivalent in order to secure the second clutch housing thrust washer (611) to the driven sprocket support assembly (609).
    2. Fig 2: Installing Case Cover Bolts Into Driven Sprocket Support Assembly
    GM893332Courtesy of GENERAL MOTORS CORP.
  2. Finger start two 13 mm case cover bolts (434) into the driven sprocket support assembly (609).
    3. IMPORTANT: If the driven sprocket support assembly (609) is not flush with or slightly below the case, then one of the clutches is not fully seated.
  3. Using the bolts (434), lift the driven sprocket support assembly (609) into the case and align as shown. The top of the driven sprocket support assembly (609) should be flush with the case.
scientia non olet · About LEMON Manuals