LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Drive Sprocket and Turbine Shaft Disassemble >> Disassembly Procedure

Disassembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Oil Seal Rings From Turbine Shaft
    GM49261Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not damage the grooves on the shaft, when removing the oil seal rings.
  1. Cut the oil seal rings (513, 519) from the turbine shaft (518).
  2. Remove the oil seal rings (513, 519).
    3. Fig 2: View Of Turbine Drive Sprocket & Retaining Ring
    GM49262Courtesy of GENERAL MOTORS CORP.
  3. Remove the drive sprocket retaining ring (515).
  4. Remove the drive sprocket (516) from the turbine shaft (518).
scientia non olet · About LEMON Manuals