LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Drive Sprocket Support Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pressing In Drive Sprocket Support Bearing With J 8092 & J 28677
    GM10582Courtesy of GENERAL MOTORS CORP.
  1. Assemble J 28677  and J 8092  . See Special Tools .
  2. Lubricate drive sprocket support bearing (521) with J 36850  .
    3. IMPORTANT: When installing the new bearing the part number should be visible (facing upward).
  3. Using the assembled tool, press in the drive sprocket support bearing (521).
    4. Fig 2: Locating Drive Sprocket Support Assembly
    GM10583Courtesy of GENERAL MOTORS CORP.
  4. Install the drive sprocket support assembly (522).
    5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the four drive sprocket support bolts (524).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals