LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Drive Shaft Oil Seal Assemble - Right Side (FWD Only) >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Installing Axle Oil Seal With J 29130 & J 8092
GM10710Courtesy of GENERAL MOTORS CORP.
NOTE: Install the seal onto the tool before installing into the case to prevent damage to the seal.
IMPORTANT: Inspect the axle oil seal assembly (4). Be sure that the seal was not damaged during assembly. Check that the garter spring was not dislodged.

Use J 29130  and J 8092  in order to install the axle oil seal assembly (4) on the case extension assembly.

scientia non olet · About LEMON Manuals