LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Drive Link Stretch Check >> Checking Procedure

Checking Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Measuring Drive Link Stretch
    GM48265Courtesy of GENERAL MOTORS CORP.
  1. Make sure that the driven sprocket support (609) and both sprockets (506, 516) are fully seated.
  2. Pull the drive link assembly (507) toward the case at the indicated location.
  3. Measure the distance between the case and the drive link assembly (507):
    • If the measurement is 3.2 mm (1/8 in) or greater, reuse the drive link assembly (507).
    • If the measurement is less than 3.2 mm (1/8 in), replace the drive link assembly (507).
scientia non olet · About LEMON Manuals