Checking Procedure
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure that the differential carrier/case thrust washer (714) and the thrust bearing (715) are still on the differential/final drive carrier assembly (700).
- Install the case extension seal (8) onto the case extension (6).
- Install the case extension assembly (6) onto the transmission (3).
- Install only two of the four case extension bolts (5).
Tighten: Do not torque the bolts. Tighten them only until the case extension is fully seated.
- Position the transmission so that the case extension is facing upward.
- Install J 25025-8 , J 26958-10A and J 8001 . See Special Tools .
- Set the dial indicator to zero.
- Use J 28585 or a large screwdriver in order to lift the differential/final drive carrier assembly. Pry up on the vehicle speed sensor reluctor wheel through the vehicle speed sensor hole in the case extension.
- Note the dial indicator reading before changing the differential carrier/case thrust washer (714):
- If the dial indicator reading is less than 0.12 mm (0.005 in), install the next smaller size thrust washer, then recheck.
- If the dial indicator reading is greater than 0.62 mm (0.025 in), install the next larger size thrust washer, then recheck.
- If the dial indicator reading is 0.12-0.62 mm (0.005-0.025 in), the thrust washer is correct.
- Remove J 8001 and J 25025-8 . See Special Tools .
- Install the case extension bolts (5).
Tighten: Tighten the case extension bolts to 36 N.m (26 lb ft).
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.
NOTE:
Use a piece of wood or rubber while prying with J 28585 or a large screwdriver, to prevent damage to VSS bore.