Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inspecting Case Side Cover

Courtesy of GENERAL MOTORS CORP.

Inspect the control valve body cover (53) for the following conditions:
- Damaged or porous gasket sealing surfaces
- Damaged or porous casting surfaces
- Damaged or stripped bolt holes
Inspect the control valve body cover gaskets (54, 59) for damage. The gaskets are reusable if they are NOT damaged.

Fig 2: Locating Control Valve Body Cover Gasket

Courtesy of GENERAL MOTORS CORP.

Assemble the control valve body cover inner gasket (59) to the control valve body cover (53). Use J 36850 or equivalent to retain the gasket in position.
Install the control valve body cover gasket (54) and control valve body cover (53) onto the case. Make sure the gaskets and electrical connector are positioned correctly.

Fig 3: Identifying Control Valve Body Cover Bolt & Control Valve Body Cover To Case Stud Bolt

Courtesy of GENERAL MOTORS CORP.

Install control valve body cover bolt (56) and one control valve body cover to case stud bolt (58) in the locations shown. These bolts will properly locate the control valve body cover and gasket to the case.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the remaining bolts as indicated:
- Nine control valve body cover bolts (56)
- Four control valve body cover TORX® head bolts (57)
- Four control valve body cover to case stud bolts (58)
  Tighten: Tighten all bolts to 25 N.m (18 lb ft).