Cleaning Procedure
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the control valve body thoroughly in clean solvent.
- Move the valves with a pick or a small screwdriver in order to dislodge any dirt or debris.
- Use an air nozzle in order to dry the control valve body and to blow out all of the passages.
- Gently probe the small passages with a piece of identification tag wire or the equivalent.
IMPORTANT:
Do not use solvent in order to clean the solenoid valves or the neoprene seals.
IMPORTANT:
In the following steps, handle the parts carefully in order to avoid nicks and scratches.