LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Case Cover Removal >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Transaxle Case Cover Bolts Locations
    GM48203Courtesy of GENERAL MOTORS CORP.
  1. Remove the indicated case cover bolts (434-436).
  2. Use J44538  to remove case cover bolt (433). See Special Tools .
    3. Fig 2: Identifying Fourth Clutch Shaft Thrust Washer & Drive Sprocket/Case Cover Thrust Washer
    GM48207Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be sure to hold the manual valve (404) in place.
  3. Lift the case cover assembly (400) off of the case.
  4. Remove the thrust washer (432).
    5. Fig 3: View Of Case Cover Upper & Lower Gasket
    GM48237Courtesy of GENERAL MOTORS CORP.
  5. Remove the upper (430) and the lower (429) case cover gaskets.
scientia non olet · About LEMON Manuals