LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Case Cover Components Disassemble (With Touch Activated Power) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating 3-4 Accumulator Piston Components
    GM330198Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not remove any of the bore plugs unless inspection indicates that replacement is necessary.
  1. Remove the manual valve (404).
  2. Remove the 3-4 accumulator piston cylinder (421) and the 3-4 accumulator piston O-ring seal (422). Use low pressure compressed air from the valve body side if necessary for removal.
  3. Remove the 3-4 accumulator piston outer spring (423) and inner spring (424).
  4. Remove the 3-4 accumulator piston (428).
  5. Remove the 3-4 accumulator piston pin (426) from the valve body side of the case cover (401).
    6. Fig 2: Expanded View Of Case Cover Components
    GM1174545Courtesy of GENERAL MOTORS CORP.
    CAUTION: Valve Springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result.
  6. Remove the actuator feed limit valve spring retainer (416).
  7. Remove the actuator feed limit valve spring (415).
  8. Remove the actuator feed limit valve (414).
  9. Remove the low regulator valve bore plug (444).
  10. Remove the low regulator valve (443).
  11. Remove the low regulator valve spring (442).
scientia non olet · About LEMON Manuals