LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Case Cover Components Assemble (Without Touch Activated Power) >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating 3-4 Accumulator Piston Components
    GM330198Courtesy of GENERAL MOTORS CORP.
  1. Install a new 3-4 accumulator piston cylinder O-ring seal (422) onto the 3-4 accumulator piston cylinder (421).
  2. Install the 3-4 accumulator piston outer spring (423) and inner spring (424) into the 3-4 accumulator piston cylinder (421).
  3. Install a new 3-4 accumulator piston seal (427) onto the 3-4 accumulator piston (428).
  4. Insert the 3-4 accumulator piston (428) into the 3-4 accumulator piston cylinder (421).
  5. Using a slight twisting motion, insert the 3-4 accumulator piston cylinder (421) into the case cover (401).
  6. Insert the 3-4 accumulator piston pin (426) through the front of the case cover (401) and into the 3-4 accumulator piston (428).
  7. Install the manual valve (404) into the case cover (401).
    8. Fig 2: Identifying Actuator Feed Limit Valve & Case Cover
    GM400527Courtesy of GENERAL MOTORS CORP.
  8. Install the actuator feed limit valve (414) into the case cover (401).
  9. Install the actuator feed limit valve spring (415) into the case cover (401).
  10. Install the actuator feed limit valve spring retainer (416) into the case cover (401).
scientia non olet · About LEMON Manuals