LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> Case Cover Bearing Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pressing Drive Shaft Bearing In With J 8092 & J 41991
    GM49306Courtesy of GENERAL MOTORS CORP.
  1. Assemble J 8092  and J 41991  for bearing installation. See Special Tools .
  2. Place the case cover (400) on a clean, flat surface with the case mating surface up.
    3. IMPORTANT: When installing the new bearing the part number should be visible (facing upward).
  3. Using the assembled tool, press the drive shaft bearing (431) into the case cover (400).
scientia non olet · About LEMON Manuals