Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Oil Pressure Test Hole Plug & Vent Assembly

Courtesy of GENERAL MOTORS CORP.

Use a hammer and a punch in order to install the vent assembly (37), if necessary.
Apply sealant GM P/N 12345382 to the oil pressure test hole plug (38).

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the oil pressure test hole plug (38).
Tighten: Tighten the oil pressure test hole plug (38) to 12 N.m (106 lb in).