LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Automatic Transaxle - 4T65-E - Overhaul) >> Repair Instructions >> 1-2 Support Roller Clutch Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2006 Saturn Relay, 2006 Pontiac Montana SV6, 2006 Pontiac Grand Prix, 2006 Pontiac G6, and 2006 Chevrolet Uplander. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Inspection Areas On 1-2 Support Roller Clutch Components
    GM10613Courtesy of GENERAL MOTORS CORP.
  1. Inspect the 1-2 support roller clutch components for the following conditions:
    • A scored or burned contact surface for the manual 2-1 band on the 1-2 support drum (687)
    • A damaged or worn forward drum bushing
    • A damaged or worn inner race of the 1-2 support roller clutch
    • A damaged or worn 1-2 clutch roller assembly (683)
    • A damaged thrust bearing (685)
    2. Fig 2: Expanded View Of 1-2 Clutch Roller Assembly
    GM10614Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Note the position of the cage assembly to the inner race.
  2. Install the 1-2 clutch roller assembly (683) into the 1-2 support drum.
  3. Install the thrust bearing (685) onto the 1-2 support drum (687). Press down with hand pressure only.
scientia non olet · About LEMON Manuals