LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Body Rear End) >> Repair Instructions >> Hinge Replacement - Rear Compartment Lid >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the hinge to the alignment marks that was made on the quarter panel.
    2. Fig 1: Rear Compartment Hinge
    GM324455Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts that attach the hinge to the rear quarter.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the rear compartment struts. Refer to Strut Replacement - Rear Compartment Lid .
  4. Install the rear compartment lid nuts. Refer to Compartment Lid Replacement - Rear .
  5. Adjust the rear compartment lid height:
    • Use an Allen wrench to turn the rear compartment hinge height adjustment bumper.
    • Turn the rear compartment lid bumper by hand.
  6. Close the rear compartment.
scientia non olet · About LEMON Manuals