LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Body Rear End) >> Repair Instructions >> Compartment Trim Panel Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the trim panels in the rear compartment.
  2. Position the trim panels on the metal supports by the rear seat back.
    3. Fig 1: Rear Compartment Trim Panel Push-In Retainers
    GM900761Courtesy of GENERAL MOTORS CORP.
  3. Install the push-in retainers.
  4. Install the floor trim panel. Refer to Floor Trim Plate Replacement - Rear .
  5. Install the seat back. Refer to Seat Back Replacement - Rear (Non-folding) or Seat Back Replacement - Rear (Folding) in Seats.
  6. Install the sill plate. Refer to Compartment Sill Plate Replacement - Rear .
  7. Install the rear compartment convenience net, if equipped.
  8. Close the rear compartment.
scientia non olet · About LEMON Manuals