LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Body Rear End) >> Repair Instructions >> Compartment Lid Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the black rubber height adjustment bumpers.
  2. Fig 1: Installing Rear Compartment Hinge
    GM318869Courtesy of GENERAL MOTORS CORP.
  3. Position the new rear compartment lid to the hinges, with an assistant.
  4. Position the hinge to the alignment marks on the rear compartment lid.
  5. Install the nuts to the rear compartment hinges.

    Do not torque the nuts until after the lid has been aligned.

  6. IMPORTANT: When installing new a compartment lid, use mechanics wire to pull the wire harness into position.
  7. Pull the harness through the rear compartment lid.
  8. Fig 2: Rear Compartment Electrical Connectors
    GM318868Courtesy of GENERAL MOTORS CORP.
  9. Connect the electrical connectors to the electrical components on the rear compartment lid.
  10. Install the latch. Refer to Latch Replacement - Rear Compartment Lid .
  11. Install the wiring harness. Refer to Wiring Harness Replacement - Rear Compartment Lid .
  12. Remove the protective coverings.
  13. Adjust the rear compartment lid if required. Using an Allen wrench, adjust the height adjustment bumper at front of the hinge.
  14. Adjust the rear compartment lid if required, for uniform fit.
  15. Fig 3: Rear Compartment Overslam Bumper
    GM318871Courtesy of GENERAL MOTORS CORP.
  16. Adjust the rear compartment height by turning the black rubber overslam bumpers by hand.
  17. NOTE: Refer to Fastener Notice .
  18. Tighten the nuts to the rear compartment hinges.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  19. Close the rear compartment.