Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the muffler and exhaust pipes over the rear axle and towards the rear of the vehicle.
- Install the exhaust hanger insulators to the exhaust pipes.
- Install rear crossover. AWD models refer to Crossmember Replacement in Frame and Underbody.
- Install a new catalytic converter gasket.
- Install the catalytic converter bolts.
Tighten: Tighten the catalytic converter bolts to 34 N.m (25 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.