Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Exhaust Hanger

Courtesy of GENERAL MOTORS CORP.

Install the exhaust system hanger (1).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the exhaust system hanger bolts (2).
Tighten: Tighten the bolts to 35 N.m (26 lb ft).

Fig 2: Locating Exhaust Hangers

Courtesy of GENERAL MOTORS CORP.

Install any exhaust insulators (1) to the exhaust system (2) and vehicle body if replacement of insulator was necessary.
Lower the vehicle.