LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.9L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Strut Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Mount Strut Bracket
    GM1675028Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount strut (1).
  2. Install the engine mount strut to engine mount strut bracket through bolt (2).
    3. Fig 2: Identifying Engine Mount Strut Bracket Through Bolt & Nut
    GM1675030Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install and tighten the engine mount strut to engine mount strut bracket through bolt (1) and nut (2).

    Tighten:  Tighten the bolt/nut to 48 N.m (36 lb ft).

    4. Fig 3: Identifying Engine Mount Strut Bracket Through Bolt
    GM1675188Courtesy of GENERAL MOTORS CORP.
  4. Install the engine harness clip (2) to the through bolt.
  5. Install the engine mount strut bracket through bolt nut (3).
  6. Tighten the engine mount strut to engine mount strut bracket through bolt (1) and nut (3).

    Tighten:  Tighten the bolt/nut to 48 N.m (36 lb ft).

  7. Install manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals