LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.9L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Strut Bracket Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Remove the air cleaner outlet duct. Refer to AIR CLEANER OUTLET DUCT REPLACEMENT .
    3. Fig 1: Identifying Engine Mount Strut Bracket Through Bolt
    GM1675188Courtesy of GENERAL MOTORS CORP.
  3. Loosen the engine mount strut to engine mount strut bracket through bolt (1) and nut (3).
  4. Remove the engine mount strut bracket through bolt nut (3).
  5. Remove the engine harness clip (2) from the through bolt.
    6. Fig 2: Identifying Engine Mount Strut Bracket
    GM1675028Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine mount strut to engine mount strut bracket through bolt (2).
  7. Rotate the engine mount strut up out of the way.
  8. Remove the 2 nuts holding the heater pipes onto the throttle body.
  9. Position the heater pipes out of the way.
    10. Fig 3: Identifying Engine Mount Lift Bracket & Bolts
    GM1675174Courtesy of GENERAL MOTORS CORP.
  10. Remove the engine mount strut/engine lift bracket bolts.
  11. Remove the engine mount strut/engine lift bracket.
scientia non olet · About LEMON Manuals