LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.9L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Strut Bracket Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Mount Lift Bracket & Bolts
    GM1675174Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount strut/engine lift bracket to the cylinder head.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount strut/engine lift bracket bolts

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Install the nuts holding the heater pipes to the throttle body.
  4. Position the back heater pipe to the throttle body.
  5. Install the nuts holding the heater pipes to the throttle body.
    6. Fig 2: Identifying Engine Mount Strut Bracket
    GM1675028Courtesy of GENERAL MOTORS CORP.
  6. Rotate the engine mount strut into position.
  7. Install the engine mount strut to engine mount strut bracket through bolt (2).
    8. Fig 3: Identifying Engine Mount Strut Bracket Through Bolt
    GM1675188Courtesy of GENERAL MOTORS CORP.
  8. Install the engine harness clip (2) to the through bolt.
  9. Install the engine mount strut bracket through bolt nut (3).
  10. Tighten the engine mount strut to engine mount strut bracket through bolt (1) and nut (3).

    Tighten:  Tighten the bolt/nut to 48 N.m (36 lb ft).

scientia non olet · About LEMON Manuals