LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.9L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement (FWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount-To-Support Frame Bolts
    GM1674892Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to AIR CLEANER OUTLET DUCT REPLACEMENT .
  2. Remove the engine mount struts. Refer to Engine Mount Strut Replacement - Left  and Engine Mount Strut Replacement - Right .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the catalytic converter. Refer to CATALYTIC CONVERTER REPLACEMENT .
  5. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  6. Remove the right engine splash shield. Refer to Splash Shield Replacement - Engine .
  7. Remove the engine mount to frame nuts.
    8. NOTE: In order to avoid oil pan damage and possible engine failure, insert a block of wood that spans the width of the oil pan bottom between the oil pan and the jack support.
  8. Place a utility stand and a block of wood under the oil pan in order to raise the engine.
    9. Fig 2: View Of Engine Mount & Bracket To-Oil-Pan Bolts
    GM1674893Courtesy of GENERAL MOTORS CORP.
  9. Remove the engine mount bracket to oil pan bolts.
  10. Remove the engine mount and bracket.
    11. Fig 3: Identifying Engine Mount Bracket Nuts
    GM1674894Courtesy of GENERAL MOTORS CORP.
  11. Remove the engine mount bracket to engine mount nuts.
  12. Remove the engine bracket from the engine mount.
scientia non olet · About LEMON Manuals