LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.9L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the flywheel to the crankshaft.
    2. Fig 1: View Of Flywheel
    GM1526753Courtesy of GENERAL MOTORS CORP.
  2. Install the flywheel bolts finger tight.
  3. Install the flywheel bolts finger tight.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Tighten the flywheel bolts.

    Tighten:   Tighten the bolts to 70 Nm (52 lb ft).

  5. Install the automatic transaxle. Refer to TRANSMISSION REPLACEMENT (M15) or TRANSMISSION REPLACEMENT (M76) .
scientia non olet · About LEMON Manuals