LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.9L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Pump Drive Installation

Oil Pump Drive Installation

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Drive
    GM1557691Courtesy of GENERAL MOTORS CORP.
  1. Apply prelube GM P/N 12345501 (Canadian P/N 992704) or the equivalent to the oil pump drive gear.
  2. Apply engine oil to the oil pump drive gear assembly for ease of assembly.
  3. Install the oil pump drive gear assembly.
  4. Install the oil pump drive gear clamp.
    5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the oil pump drive gear clamp bolt.

    Tighten:  Tighten the oil pump drive gear clamp bolt to 36 N.m (27 lb ft).

scientia non olet · About LEMON Manuals