Assembly Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate all the internal oil pump parts using engine oil during assembly.
- Install the oil pump gears.
- Install the oil pump cover.
- Install the oil pump cover bolts.
Tighten: Tighten the oil pump cover bolts to 10 N.m (89 lb in).
- Install the pressure regulator valve.
- Install the pressure regulator spring.
- Install the cotter pin.
- Apply sealer GM P/N 12346004, (Canadian P/N 10953480) or the equivalent to the new suction pipe.
- Tap the new suction pipe into place using a plastic hammer and J 22144 .
IMPORTANT:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.
IMPORTANT:
Make sure the cotter pin is properly secured.