LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.9L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Mount Support and Strut Bracket Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount Support & Strut Bracket Bolts
    GM1645437Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount support and strut bracket and bracket bolts.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Tighten the bolts.

    Tighten:   Tighten the bolts to 50 Nm (37 lb ft).

scientia non olet · About LEMON Manuals