LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.9L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Flywheel Installation (Manual Transmission) >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

J 45059  Angle Meter

    Fig 1: Identifying Flywheel Bolts (Manual Transmission)
    GM1608905Courtesy of GENERAL MOTORS CORP.
  1. Install the clutch pilot bearing.
  2. Install the flywheel/pressure plate.
  3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the flywheel/pressure plate bolts.

    Tighten:  Tighten the flywheel/pressure plate bolts to 50 N.m (37 lb ft) plus an additional 70 degrees using the J 45059  .