LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Engine Mechanical - 3.9L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft Rear Bearing Hole Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Coat the camshaft rear bearing hole plug with sealer. Refer to Sealers, Adhesives and Lubricants .
    2. Fig 1: View Of Camshaft Rear Bearing Hole Plug
    GM105921Courtesy of GENERAL MOTORS CORP.
  2. Install the camshaft rear bearing hole plug.
    3. Fig 2: Identifying Camshaft Rear Bearing Hole Plug Installation Depth
    GM187008Courtesy of GENERAL MOTORS CORP.
  3. Ensure that the camshaft rear bearing plug is installed to specifications.
  4. Install engine flywheel. Refer to Engine Flywheel Replacement .
scientia non olet · About LEMON Manuals