LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Engine Controls - 3.5L - DTC P0496 To DTC U1017) >> DTC P1516 >> Test Description

Test Description

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 3:  Both TP sensor DTCs active at the same time will result in DTC P1516 also set. It is necessary to diagnose both sensor faults individually.
  2. 4:  A DTC U0107 set along with a sensor DTC may indicate a sensor fault. Refer to the sensor diagnostic table first.
DTC P1516

Step Action Values Yes No
Schematic Reference: Engine Controls Schematics (LX9)
Connector End View Reference: Powertrain Control Module (PCM) Connector End Views and Engine Controls Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2 Is DTC P2108 also set? - Go to Diagnostic Trouble Code (DTC) List - Vehicle Go to Step 3 
3  Are DTCs P0120 and P0220 both set? - Go to Diagnostic Trouble Code (DTC) List - Vehicle Go to Step 4 
4  Is DTC U0107 set along with DTC P0120, P0220, P2120 or P2125? - Go to Step 6  Go to Step 5 
5 Is DTC U0107 also set? - Go to Diagnostic Trouble Code (DTC) List - Vehicle Go to Step 8 
6 Diagnose the appropriate sensor DTC first.
Did you find and correct the condition?		 - Go to Step 9  Go to Step 7 
7
  1. Turn OFF the ignition for 15 seconds.
  2. Turn ON the ignition, with the engine OFF.
  3. Observe the TP sensor 1 and TP sensor 2 angle parameter with a scan tool.
  4. Slowly depress the accelerator pedal to wide open throttle (WOT) and then slowly return the pedal to closed throttle.
Does the throttle position (TP) sensor 1 and TP sensor 2 angle increase to near the specified value as the pedal is depressed and decrease as the pedal is released?		 100% Go to Diagnostic Aids Go to Step 8 
8 Replace the throttle body assembly. Refer to Throttle Body Assembly Replacement .
Did you complete the replacement?		 - Go to Step 9  -
9
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?		 - Go to Step 2  Go to Step 10 
10
IMPORTANT: Be aware that repairing one individual condition may correct more than one DTC.
Observe the Capture Info with a scan tool.Are there any DTCs that have not been diagnosed?		 - Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK
scientia non olet · About LEMON Manuals