Repair Procedures
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Always perform the Diagnostic Repair Verification
after completing the repair.
- Clear the DTCs with a scan tool.
- Turn OFF the ignition for 30 seconds.
- Start the engine. If engine does not run, refer to Engine Cranks but Does Not Run .
- If other DTCs are set, refer to Diagnostic System Check - Vehicle .