Circuit/System Description
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
The control module has 2 internal 5-volt reference busses called 5-volt reference 1 and 5-volt reference 2. Each reference bus provides 5-volt reference circuits for more than one sensor. Therefore, a fault condition on one 5-volt reference circuit will affect the other 5-volt reference circuits connected to that reference bus. The control module monitors the voltage on the 5-volt reference busses.
The 5-volt reference 1 bus provides 5 volts to the following sensors:
- The manifold absolute pressure (MAP) sensor
- The fuel tank pressure (FTP) sensor
- The accelerator pedal position (APP) sensor 2
- The engine oil pressure (EOP) switch
- The camshaft position (CMP) sensor
The 5-volt reference 2 bus provides 5 volts to the following sensors:
- The APP sensor 1
- The throttle position (TP) sensor 1 and 2
- The air conditioning (A/C) refrigerant pressure sensor
- The crankshaft position (CKP) sensor