LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 231 (Engine Controls - 3.9L - DTC P0442 To P2A01) >> DTC P0451, P0452, P0453 or P0454 >> Circuit/System Testing >> P0451 and P0454

P0451 and P0454

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Refer to the J 41413-200  operation manual for detailed instructions.
  1. Start the engine with the J 41413-200  connected to the fuel filler neck.
  2. Allow the engine to idle.
  3. Use the Purge/Seal function to seal the system with a scan tool.
  4. Command the EVAP canister purge solenoid valve to 30 percent.
  5. Observe the vacuum/pressure gage on the J 41413-200  and the FTP parameter on the scan tool.
  6. Allow the vacuum to increase on the gage of the J 41413-200  until it reaches approximately 16 inches H2O or until the vacuum reached the abort limit on the scan tool.
  7. Use the Purge/Seal function to seal the system with a scan tool.
  8. If the difference between the FTP parameter on a scan tool and the vacuum/pressure gage on the J 41413-200  is more than 1 inch H2O, replace the FTP sensor.
  9. If the Fuel Tank Pressure Sensor parameter on a scan tool display is less than 3.2 volts, replace the FTP sensor.
scientia non olet · About LEMON Manuals