Circuit/System Testing: P0112
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ON the ignition, with the engine OFF.
- Disconnect the mass air flow (MAF)/IAT sensor. Observe the intake air temperature (IAT) sensor with a scan tool for -36°C (-33°F).
- If more than -36°C (-33°F), test the signal circuit of the IAT sensor for a short to ground or a short to the IAT low reference circuit and repair as necessary. If all circuits test OK then replace the control module.
- If less than -36°C (-33°F), replace the MAF/IAT sensor.
- If IAT signal circuit tests OK, then replace the control module.