Conditions for Setting the DTC: P0010

The engine control module (ECM) detects that the state of the driver and the state of the circuit do not match. The ECM will detect an open, short to ground or a short to voltage on the high control circuit or an open on the low reference circuit for more than 6.25 seconds.

P0011

• The difference between the desired CMP and the actual CMP angle is more than 8 degrees for more than 8 seconds while the CMP actuator is being commanded.

  OR

• The difference between the desired CMP and the actual CMP angle is more than 7.5 degrees when the CMP actuator is steady for more than 2 seconds.