LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Disc Brake System) >> Repair Instructions >> Disc Brake Hardware Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Brake Dust Caution in Cautions and Notices.
    Fig 1: View Of Brake Caliper And Caliper Bracket
    GM178630Courtesy of GENERAL MOTORS CORP.
  1. Remove the brake caliper from the mounting bracket and support the brake caliper (2) with heavy mechanic's wire (1) or equivalent. It is not necessary to disconnect the hydraulic brake flexible hose from the caliper. Refer to Brake Caliper Replacement - Rear .
    2. Fig 2: Exploded View Of Rear Brake Caliper Components
    GM176945Courtesy of GENERAL MOTORS CORP.
  2. Remove the brake pads (9, 10) from the brake caliper bracket (12).
  3. Remove the brake pad retainers (11) from the brake caliper bracket (12).
  4. Remove the brake caliper bracket (12). Refer to Brake Caliper Bracket Replacement - Rear .
  5. Mount the brake caliper bracket (12) in a vise.
scientia non olet · About LEMON Manuals